Dryer Features; Estimated Time Remaining; Drum Lamp - GE GFDN240 Owner's Manual

About cycle options.
About dryer features.
26
NOTE: Not all features are available on all dryer models.
Lock
You can lock the controls to prevent any
selections from being made. You can also lock
the controls after you have started a cycle.
Children cannot accidentally start the dryer
by touching pads with this option selected.

Estimated Time Remaining

Displays the approximate time remaining until
the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will "race" in the display. This means
the dryer is continuously monitoring
My Cycle
To save a favorite cycle, set the desired settings
and hold down the MY CYCLE button for 3
seconds. A beep will sound to indicate the cycle
has been saved.
To use your custom cycle, press the MY CYCLE
button before drying a load.

Drum Lamp

Before replacing the light bulb, be sure to unplug the dryer power cord or
disconnect the dryer at the household distribution panel by removing the fuse or
switching off the circuit breaker. Reach above dryer opening from inside the drum.
Remove the bulb and replace with the same size bulb.
Note: Drum lamp only (and automatically) turns on when the dryer door is open.
Drying Rack (on some models)
A handy drying rack may be used for drying delicate items such as washable
sweaters. Place items flat on the drying rack and block such items as wool
sweaters and delicate fabrics. Dry with low heat.
To install the drying rack, pull up the lint filter slightly. Insert the drying rack into
the slots, then push the filter back down.
NOTE:
„ The drying rack is designed for use with the TIMED DRY cycles. Use with sensor
cycles may result in damp items or extended cycle times.
„ Do not use this drying rack when there are other clothes in the dryer, that are
not placed on the rack.
To lock the dryer, press the lock icon. To unlock
the dryer, press and hold the lock icon for 3
seconds.
The Lock icon next to the timer will light up
when the controls are locked.
the amount of moisture in the load.
The lights will continue until the dryer senses a
low level of moisture in the load. At that point,
the dryer will calculate and display
the approximate time remaining.
To change the saved cycle, set the desired
settings and hold down the MY CYCLE button
for 3 seconds.