Dryer Features; Estimated Time Remaining; Drum Lamp - GE GFDL110 Owner's Manual

About cycle options.
About dryer features.
10
NOTE: Not all features are available on all dryer models.
Lock
You can lock the controls to prevent any
selections from being made. You can also lock
the controls after you have started a cycle.
Children cannot accidentally start the dryer
by touching pads with this option selected.

Estimated Time Remaining

Displays the approximate time remaining until
the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will "race" in the display. This
means the dryer is continuously monitoring
My Cycle (on some models)
To save a favorite cycle, set the desired
settings and hold down the My Cycle button
for 3 seconds. A beep will sound to indicate
the cycle has been saved.
To use your custom cycle, press
the My Cycle button before drying a load.

Drum Lamp

The drum lamp comes on automatically when the door is opened.
Before replacing the light bulb, be sure to unplug the dryer power cord
or disconnect the dryer at the household distribution panel by removing
the fuse or switching off the circuit breaker. Reach above dryer opening
from inside the drum. Remove the bulb and replace with the same size bulb.
To lock the dryer, press and hold the lock icon
for 3 seconds. To unlock the dryer, press and
hold the lock icon for 3 seconds.
The Lock icon next to the timer will light up
when the controls are locked.
the amount of moisture in the load.
The lights will continue until the dryer senses a
low level of moisture in the load. At that point,
the dryer will calculate and display
the approximate time remaining.
To change the saved cycle, set the desired
settings and hold down the My Cycle button
for 3 seconds.