Table of Contents
Advertisement
Installation
STEP 16 Align the Safety Reversing Sensors
IMPORTANT: The safety reversing sensors MUST be connected and aligned correctly before the garage
door opener will move in the down direction.
When the garage door opener has power, check the safety reversing sensors. If the sensors are aligned and
wired correctly, both LEDs will glow steadily.
Light Beam Protection Area
Sending sensor - amber LED
To align the safety reversing sensors:
1.
Loosen the wing nuts.
2.
Adjust the sensors up or down until both LEDs glow steady indicating alignment.
3.
Tighten the wing nut to secure the sensor.
Receiving sensor - green LED
Wing nut
29
SAFETY SENSOR TROUBLESHOOTING
If either of the sensor LEDs are off, there is no power to the sensor:
1.
Check that you have power to the garage door opener.
2.
Check the sensor wire is not shorted or broken.
3.
Check that the sensors are wired correctly; white wires to white terminal and white/black wires to grey
terminal.
1
If the green receiving sensor LED is blinking, the sensors are obstructed or misaligned:
1.
Check for obstructions in the sensor light beam.
2.
Align the sensors.
3.
If the receiving sensor (green LED) faces direct sunlight, switch the receiving sensor with the sending
sensor and repeat STEP 12 Install the Protector System® page 24 to assure proper operation.
STEP 17 Ensure the Door Control is Wired Correctly
The LED behind the push button on the door control will blink if installed correctly.
3
2
Hide quick links:
Advertisement
Table of Contents
