Mounting The Transducer - Interphase PC/View Operation Manual

Mounting the Transducer

After you have selected a mounting location and at-
tached the mounting brackets to the transducers, po-
sition each transducer-bracket assembly so it is level
in both the fore-aft and port-starboard directions.
Check the orientation of your boat's waterline and
position the flat top surface of the transducer so that
it is parallel to the waterline as shown on the follow-
ing page.
Mount the bracket on the hull as shown in the dia-
grams at right and on the following page. Once the
transducer is properly positioned, tighten the lock
nuts.
Transom Mount Locations
Cable
Transducer
Cables
Twin Outboards
Attach Transducer and Spray Shield to
Rear View
Side
18 - 24"
View
11
Bracket
Spray
Shield
Boat's Hull
Fasten with
4 screws &
nylock
washers as
shown