Titan TTB939SHR Manual page 24

Operation / Care and maintenance
EN EN
After use
1. Switch the product off, disconnect the plug from the power supply and let it
cool down.
2. Check, clean and store the product as described below.
The golden rules for care
WARNING! Always switch the product off, disconnect the plug from the
power supply. Let the product cool down before performing inspection,
maintenance and cleaning work!
1. Keep the product clean. Remove debris from it after each use and before
storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
3. Inspect the product before each use for worn and damaged parts. Do not
operate it if you find broken and worn parts.
WARNING! Only perform repairs and maintenance work according to
these instructions! All further works must be performed by a qualified
specialist!
General Cleaning
1. Clean the product with a dry cloth. Use a brush for areas that are hard to
reach.
2. In particular clean the air vents (4) after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
4. Check for worn or damaged parts. Replace worn parts as necessary or
contact an authorised service centre for repair before using the product again.
24
MNL_TTB939SHR_2400W Impact Shredder_GB_V1_220323.indd 24 MNL_TTB939SHR_2400W Impact Shredder_GB_V1_220323.indd 24
TTB939SHR by TITAN
2022/3/23 3:36 PM 2022/3/23 3:36 PM