Titan TTB939SHR Manual page 15

TTB939SHR by TITAN
Assembly
WARNING! The product must be fully assembled before operation!
Do not use a product that is only partly assembled or assembled with
damaged parts!
Follow the assembly instructions step-by-step and use the pictures
provided as a visual guide to easily assemble the product!
Do not connect the product to power supply before it is completely
assembled!
Always wear protective gloves during assembly! Beware of sharp
edges on the product.
NOTE: Take care of small parts that are removed during assembly or
when making adjustments. Keep them secure to avoid loss.
Frame / wheels assembly
1. Place cardboard or an old blanket on floor, then carefully place the main unit
(3) upside down.
2. Align and insert the frame (11) into the two supports (3a) to the end (Fig. 1,
step 1). Ensure that the screw holes between the frame (11) and the support
(3a) are well aligned. Use a rubber mallet if necessary.
3. Secure the connections with the screws (3b) (Fig. 1, step 2). Make sure that
the screw head is flush with the housing of the supports (3a).
4. Align the wheel axle (12) with the holes on the frame (11) and insert it through
both sides (Fig. 1, step 3). Ensure that the wheel axle (12) is centred.
5. Align and place one wheel (13) onto the wheel axle (12) (Fig. 2, step 1).
6. Pass the washer (13b) through the wheel axle (12) (Fig. 2, step 2).
7. Secure the connection by passing R-clip (13c) through the hole of wheel axle
(12) (Fig. 2, step 3).
MNL_TTB939SHR_2400W Impact Shredder_GB_V1_220323.indd 15 MNL_TTB939SHR_2400W Impact Shredder_GB_V1_220323.indd 15
11
3a
1.
3.
12
3
Fig. 1
Before you start
2.
3b
EN
15
2022/3/23 3:35 PM 2022/3/23 3:35 PM