Titan TTB939SHR Manual page 21

TTB939SHR by TITAN
2. Double check that accessories or attachments are properly fixed.
3. Always carry the product on its transportation handle. Keep the transportation
handle dry and clean to ensure safe support.
4. Ensure that the air vents (4) are always unobstructed and clear. Clean them
if necessary with a soft brush. Blocked air vents may lead to overheating and
damage the product.
5. Switch the product off immediately if you are disturbed while working by other
people entering the working area. Always let the product come to complete
stop before averting.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
7. Inspect the material to be shredded before starting. Remove any objects or
debris that could be thrown, jammed or become entangled in the blades.
Remove any soil from root balls. Foreign bodies like stones, glass, metals,
fabrics or plastics must not enter the feeding funnel, these could damage the
blades.
8. Always place the product on firm, level ground. During operation, do not tilt
or move the product.
9. Allow the cutting means to reach full speed before feeding the material into
the feeding funnel.
10. Do not fill soft waste such as kitchen rubbish into the feeding funnel, but
compost them.
11. Long material extending out from the product could lash out when being
drawn in by the blades. Keep at safe distance.
12. Only insert as much material so that the feeding funnel will not be blocked up.
13. Keep hold of branches while feeding them into the product until they are
automatically drawn in.
14. Soft materials (e. g. leaves, stems) may block the opening of feeding funnel.
Use plunger to push them onto the cutting means if necessary.
15. Always feed the material, especially the branches, into the larger opening of
the feeding funnel.
16. Keep to the working speed of the product and do not overload it.
17. Keep a few dry branches for the end, as they will help clean the product.
18. Only switch the product off when all of the shredding material has passed
through the discharge chute. Otherwise, the discharge chute may jam the
next time you switch the product on.
19. Ensure the shredded material can fall freely from the discharge chute.
20. To make finer compost the shredded material can be shredded for a second
time.
21. Do not allow the shredded material to build up to a level where it blocks the
discharge chute. If the material builds up too far, it could reach the cutting
blades and be thrown out of the feeding funnel.
MNL_TTB939SHR_2400W Impact Shredder_GB_V1_220323.indd 21 MNL_TTB939SHR_2400W Impact Shredder_GB_V1_220323.indd 21
Operation
EN EN
21
2022/3/23 3:35 PM 2022/3/23 3:35 PM