Titan TTB939SHR Manual page 22

Operation
EN EN
General operation
22. Organic material contains a large amount of water and sap that can stick to
the product. To avoid this, the material should be left for a few days to dry out.
Large branches however are best shredded when they are fresh.
23. If the cutting means stalls during operation, stop the product immediately and
disconnect the product from the power supply before investigating the cause.
24. Remove any jammed debris from the cutting means and examine them for
any damage before re-commencing shredding.
25. If the blades have stalled the motor will be overheated. Stop the motor
immediately and let it cool before removing blockages.
Collection bag
1. Always operate the product with the collection bag (5) attached.
2. Inspect the collection bag (5) each time before use. Do not use it if you detect
any damage.
3. Empty frequently during use. Do not wait until the collection bag (5) is
completely full. We recommend emptying it when it is half full.
4. Switch the product off and disconnect it from the power supply.
5. Use the hanging belts (5a) to carry the collection bag (5). Empty the chippings
on compost heap or into a suitable container.
6. Re-fit the collection bag (5) before using the product again.
Shredding
1. Ensure the extension cord is well hooked on the cord retainer (10). Connect
the plug to the power supply via the extension cord.
2. Stand behind the transportation handle (1).
3. Chop the damp / wilted garden waste which has been stored for several days
before feeding them into the feeding funnel (2).
4. Ensure the collection bag (5) is securely attached onto the hooks (3c) of the
main unit (3).
5. Turn the on/off switch (7) clockwise to switch the product on (Fig. 8).
6. Slowly feed material (e. g. garden waste, branches) into the feeding funnel
(2) (Fig. 9). Only insert as much feeding material as to avoid blockage of
feeding funnel (2) and cutting blade (16).
7. Insert the plunger (21) into the feeding funnel (2) to push the material onto the
cutting blade (16) if necessary (Fig. 10).
8. Wait until all the feeding material has been shredded before adding more
material.
22
MNL_TTB939SHR_2400W Impact Shredder_GB_V1_220323.indd 22 MNL_TTB939SHR_2400W Impact Shredder_GB_V1_220323.indd 22
TTB939SHR by TITAN
2022/3/23 3:36 PM 2022/3/23 3:36 PM