Driveline Installation - Land Pride RTR2570 Operator's Manual

Section 1: Assembly & Set-up
23550
Pull Collar
Coupler
Tractor End
Slip Clutch Protection With Conical-dog Coupler Pin
Figure 1-4

Driveline Installation

Refer to Figure 1-4:
The driveline supplied with the tiller has a friction slip
clutch with a pull collar coupler on the tractor end and a
conical-dog pin coupler on the implement end. Always
engage power take-off at low engine rpm to minimize
start-up torque loads.
IMPORTANT: The driveline must be lubricated
before putting it into service. Refer to "Lubrication
Points" on page 27.
12
RTR2570 Rotary Tillers 311-251M
Table of Contents
Driveline Installation
Figure 1-5
Implement End
Slip Clutch Protection
With
Conical-dog pin coupler
Refer to Figure 1-5:
1. Remove bolts (#9) and gearbox cover (#4).
2. Remove gearbox shaft protector (#10) and discard.
3. Remove existing nut, flat washer, and conical-dog
pin from driveline coupler (#1).
4. Slide coupler (#1) onto the gearbox input shaft. Align
the conical-dog pin hole in the coupler with the
groove around the gearbox input shaft.
5. Attach coupler to the input shaft with removed
conical-dog pin, flat washer, and nut. Tighten nut to
the correct torque.
6. Push/pull on the coupler to ensure it is securely
fastened to the gearbox input shaft.
7. Secure gearbox protection cover (#4) to the 3-point
hitch frame with removed bolts (#9). Tighten bolts to
the correct torque.
8. Collapse driveline (#7) by pushing the tractor
end of the driveline toward the implement.
8/30/22