Table of Contents
Advertisement
Section 1: Assembly & Set-up
Park Jack Assembly
Refer to Figure 1-9:
Attach parking jack (#1) to hitch frame and secure with
attached detent pin (#2). Adjust jack up or down until
clevis hitch is at drawbar height.
Driveline Assembly
Refer to Figure 1-10:
!
WARNING
To avoid serious injury or death:
!
DANGER
To avoid serious injury or death: Make certain driveline
yokes are securely fastened at each end. A loose yoke can work
free allowing the driveline to rotate uncontrollably causing
implement damage and bodily injury or death to anyone
nearby.
IMPORTANT: The driveline must be lubricated
before putting it into service. Refer to "Lubrication
Points" on page 47.
The main driveline may be either constant velocity type
or conventional type. Pull-collar couplers and retaining
bolts are used to connect the driveline to the tractor and
implement gearbox, respectively.
1.
Park tractor and cutter in a straight line on a level
surface. Place gear selector in park, shut tractor
engine off, set park brake, and remove switch key.
2. Verify "Drawbar Set-up" dimensions on page 13 are
correct before installing driveline.
3. Remove hand knobs (#8).
4. Rotate front half of splitter guard (#9) open.
5. Unsnap doors (#7) on both sides of splitter guard (#6)
and rotate doors down.
6. Remove and discard rubber shaft protector (#4) from
splitter gearbox input shaft.
7.
Remove locknuts (#1) and bolts (#2) from bolted
coupler end of driveline (#5).
8. Slide bolted coupler end of driveline (#5) over splitter
gearbox input shaft until bolt holes in coupler align
with groove around input shaft.
9. Attach driveline (#5) to splitter gearbox input shaft
with removed bolts (#2) and locknuts (#1). Tighten
locknuts to the correct torque.
10. Pull on driveline yoke to ensure yoke is securely
fastened to splitter gearbox shaft.
11. Rotate doors (#7) up and snap shut.
12. Collapse driveline (#5) by pushing tractor end of
driveline toward splitter gearbox.
13. Rotate front half of splitter guard (#9) shut and s.
14. Secure splitter guard with hand knobs (#8).
16
RC3620 & RCM3620 Rotary Cuters 330-841M
Table of Contents
2
1
Parking Jack Assembly
Figure 1-9
Driveline Assembly
Figure 1-10
22149
37999
9/25/18
Advertisement
Table of Contents
