Check Driveline Collapsible Length - Land Pride RTR2570 Operator's Manual

Section 1: Assembly & Set-up
22311
Check Driveline Minimum Length
Figure 1-7

Check Driveline Collapsible Length

Refer to Figure 1-7:
IMPORTANT: A driveline that is too long can bottom
out causing structural damage to the tractor and
implement. Always check driveline minimum length
during initial setup, when connecting to a different
tractor, and when alternating between using a quick
hitch and a standard 3-point hitch. More than one
driveline may be required to fit all applications.
IMPORTANT: The power take-off shaft and gearbox
input shaft must be aligned and level with each other
when checking driveline minimum length. A driveline
that is too long can damage tractor and implement.
1. With driveline attached only to the 3-point implement,
remove outer driveline (tractor end) from inner
driveline to separate the two profiles.
2. Park tractor and implement on a level surface.
3. Raise implement until gearbox input shaft is level
with tractor power take-off shaft. Securely block
implement at this height to keep unit from lowering.
4. Shut tractor down without removing support blocks.
Refer to "Tractor Shutdown Procedure" on page
13.
5. Attach outer driveline to the tractor's power take-off
shaft. Refer to steps 2-8 under "Driveline Hook-up"
on page 15.
6. Hold inner and outer drivelines parallel to each other.
If dimension "A" is greater than or equal to 1" (2.5 cm),
then skip to "Check Driveline Maximum Length" on
page 17. Otherwise continue with step 7.
16
RTR2570 Rotary Tillers 311-251M
Table of Contents
22311
22311
Refer to Figure 1-8:
7. If dimension "A" was less than 1" (2.5 cm), shorten
driveline as follows:
a. Measure 1" (2.5 cm) ("B1" dimension) back from
outer driveline shield and make a mark at this
location on the inner driveline shield.
b. Measure 1" (2.5 cm) ("B2" dimension) back from
the inner driveline shield and make a mark at this
location on the outer driveline shield.
8. Remove outer driveline from the tractor power take-
off shaft and inner driveline from the implement's
gearbox shaft.
9. Cut off non-yoke end of inner driveline as follows:
a. Measure from end of inner shield to scribed mark
("X" dimension) and record.
b. Cut off inner shield at the mark. Cut same amount
off the inner shaft ("X1" dimension).
10. Cut off non-yoke end of outer driveline as follows:
a. Measure from end of outer shield to scribed mark
("Y" dimension) and record.
b. Cut off outer shield at the mark. Cut same amount
off the outer shaft ("Y1" dimension).
11. Remove all burrs and cuttings.
12. Continue with "Check Driveline Maximum Length"
on page 17.
Driveline Shortening
Figure 1-8
8/30/22