Omega OME-ET-7000 Series User Manual page 79

Step 8
Add a DO that is to be used to
write the "Motor" out put to turn
the conveyor motor on and off
Set the Motor as an output (use
the Modbus Register 0 (DO0)),
and then select Coil and Write as
the Register Type and enter
Motor as the Alias, as shown in
the figure below.
Step 9
Save the selected sensor settings
Click the "Save" button to complete setup and save the register
settings.
By selecting "write" as the Register type, control button
will be shown on the web page. (Refer to Step 10)
DO0
Page: 74