Troubleshooting - Jacuzzi LINK 160x70 Installation Manual

Single-control mixer tap
A B
It is advisable to adjust the water temperature to the desired value
before using any function as follows:
I Turn the diverter valve dial (G) to the "tub filling" position (D).
I Lift the mixer lever (M) and turn it rightwards or leftwards to
obtain a pleasant temperature.
I Once the required water temperature is reached, turn the dial (G)
to the position of the function you wish to use.
Note: It is advisable to return the diverter valve to the "tub filling"
position after using the functions.

Troubleshooting

PROBLEM / solution
NO WATER FROM THE VARIOUS FUNCTIONS (HAND
SHOWER, VERTICAL HYDROMASSAGE, ETC.)
Open the mixer tap.
LOW PRESSURE FROM THE SHOWERHEAD
Clean the filter between the flexible hose and hand shower.
LITTLE WATER FROM ALL FUNCTIONS
• Check that the installer has respected the pressure/flow rate
conditions shown on the pre-installation sheet.
• Check that the thermostat valve filter is not obstructed by dirt
and/or lime scale.
C D
G
M
LOW PRESSURE FROM VERTICAL HYDROMASSAGE
Clean the nozzles. If this is not sufficient, contact a Jacuzzi® Service
Centre to have the water pressure and flow rate checked.
DIFFICULTY IN ADJUSTING WATER TEMPERATURE
(MIXING)
Check that the hot and cold water pressures are balanced.
Contact your plumber if the values are different.
Maintenance
TAPS AND ALUMINIUM PARTS
Simply dry the various components after use and remove dirt with
a cloth and soapy water or mild detergent. Rinse with clean
water and dry.
Do not use abrasive pads, detergent powders, acetone or
other solvents.
NOZZLES (vertical hydromassage)
SHOWERHEAD
HAND SHOWER
These components are provided with a scale removal membrane
which may be cleaned with a sponge. Refer to the instructions for
taps for normal cleaning operations.
CLEANING THE THERMOSTAT VALVE
The thermostat valve is provided with a net filter to withhold
impurities. The filters could get obstructed in time; proceed as
follows to clean:
I Shut off the water (hot and cold) to the shower box.
I Drain water from the mixer by turning the dial (G) to the "tub
filling" position and open the stop tap (R); then close the stop tap
and return the knob to the previous position.
I (1) Remove the cap (T) from the mixer knob.
I (2-3-4) Remove the screw (V), loosen the knob (M) and the cover
from the mixer (C).
13