Table of Contents
Advertisement
EasyCoder
F-Series
Intermec EasyLAN 100i – Installation Instructions Ed. 1
This description applies to Intermec EasyCoder F2 and Intermec
EasyCoder F4 only.
• Open the electronics compartment by removing the font/left-hand
cover, which is held by three (3) #T20 Torx screws from the
paper compartment side of the centre-line wall.
• Important!
Turn off the power and disconnect the power cord.
The electronics compartment contain high voltage components
and wires. Do not open the electronics compartment before the
printer is safely disconnected from any mains supply.
Chapter 2
Physical Installation
#T20 Torx screws (x3)
7
Advertisement
Table of Contents
