Table of Contents
Advertisement
Description
Printer Firmware
Installation Kit
Intermec EasyLAN 100i – Installation Instructions Ed. 1
Attaching your EasyCoder 501XP, 601XP, F2 & F4 label printers
to the network has just become easier with Intermec's EasyLAN
100i Ethernet interface. In addition, the EasyLAN 100i interface
board provides you with the most advanced network management
capa-bilities ever offered. The EasyLAN 100i interface is designed
to accommodate your network. With the most robust network sys-
tems support ever offered your label printers will be up and running
on your network in minutes.
Save time, space and money by putting the printer where you need
it. No need for a dedicated PC work-station or long serial or paral-
lel cables. Simply locate your label printer in the most efficient
place for your business, connect your RJ-45 network cable to the
printer and begin printing. Now you can print from workstations or
servers anywhere across the LAN, WAN, Intranet, or Internet. In
addition, you can monitor the status of print jobs from your Intranet
or Internet, any place any time using your favorite web browser.
Now you can take full advantage of the incredible bandwidth of
your 100baseTX Fast Ethernet network infrastructure. When you
combine the EasyLAN ETRAX 100 network processor with the
EasyCoder 501XP, 601XP, F2, or F4's 32 bit RISC processor, print
jobs, including complex labels with bar codes, text and graphics,
are sent to the printer at lightning speed providing you with full
rated printer performance.
When your business depends on your label printer, you can depend
on the Intermec EasyLAN 100i Ethernet network interface board to
provide you with dependable service and advanced management
capabilities.
The printer must be fitted with Intermec Fingerprint v. 7.31 or later.
The Ethernet port is addressed as device "net1:" (communication
channel #5).
The EasyLAN 100i kit contains:
• One EasyLAN 100i Ethernet interface board.
• One cover plate (used in EasyCoder XP-series printers only).
• One flat cable (used in EasyCoder F-series printers only)
• One CD-ROM with software and manuals
• This Installation Instruction booklet
The only tools required for the installation are #T10 and #T20 Torx
screwdrivers.
Chapter 1
Introduction
3
Advertisement
Table of Contents
