Table of Contents
Advertisement
Assigning an IP
Address, cont'd.
Choosing the "Manual" option
will disable DHCP, BOOTP, or
RARP.
Intermec EasyLAN 100i – Installation Instructions Ed. 1
Setting the IP address automatically from the Setup Mode
In addition to setting the IP address manually, as described above,
there are three methods for making the network server automati-
cally assign an IP address for your EasyLAN 100i printer.
- DHCP
- BOOTP
- RARP
Method
UNIX
DHCP
X
BOOTP
X
RARP
X
• Press the Setup key on the printer's built-in keyboard. This mes-
sage appears in the display window:
SETUP:
SER-COM, UART1
• Press the F4 key and the following message appears:
SETUP:
NETWORK
• Press the Enter key. The display shows:
NETWORK:
IP SELECTION
• Press the Enter key. The display shows one of the following
messages:
IP SELECTION:
DHCP
BOOTP
RARP
Use the F4 or F5 key to scroll in this loop of options. When
DCHP, BOOTP, or RARP is displayed, press the Enter key.
By selecting DCHP, BOOTP, or RARP, that option will be ena-
bled, which you can see if you open the printers home page
(Configuration;Network Interface;TCP/IP). The option you have
selected will appear first next time you enter this loop.
Chapter 4
Windows
Comments
X
Automatic but temporary assignment of
IP addresses from a central pool. IP ad-
dress may change unexpectedly, e.g.
after a power off.
Similar to RARP, although can operate
on the entire network.
Downloads the IP address automatically.
MANUAL
Communication Setup
13
Advertisement
Table of Contents
