Table of Contents
Advertisement
Printing
Test Label #6
Intermec EasyLAN 100i – Installation Instructions Ed. 1
You can easily check the IP address and other network setup pa-
rameters by printing a test label. When an EasyLAN 100i interface
board is fitted, a sixth test label becomes available. You can print
test label #6 either via the Setup Mode or via a Fingerprint applica-
tion.
Setup Mode
• Enter the Setup Mode by pressing the Setup key on the printer's
built-in keyboard. The display shows:
SETUP
SER-COM,UART1
• Press the F5 key repeatedly until the following menu appears:
SETUP:
PRINT DEFS
• Press Enter. The display shows:
PRINT DEFS:
HEAD RESIST
• Press the F5 key. The display shows:
PRINT DEFS:
TESTPRINT
• Press Enter. The display shows:
<ENTER> = PRINT:
<F5> = NEXT #1
• Press the F5 key repeatedly until the display shows:
<ENTER> = PRINT:
<F5> = NEXT #6
• Press the test button on the rear plate of the EasyLAN 100i inter-
face board and keep it depressed while pressing Enter on the
printer's keyboard. The test label is printed.
• Press the Setup key to leave the Setup Mode.
Fingerprint application
IMMEDIATE ON
OPEN "status:" FOR INPUT AS #1
IF LOC(1)<>0 THEN SETUP "PRINT_DEFS,<ENTER>_=_PRINT,<F5>_=_NEXT_#6"
IMMEDIATE OFF
RUN
Chapter 4
Communication Setup
17
Advertisement
Table of Contents
