Setup Mode Overview - Intermec EasyLAN 100I Installation Instructions Manual

Chapter 4 Communication Setup
Setup Mode
Overview
Standard Setup Mode
SETUP:
See diagram #1 in printer's
SER-COM, UART1
Installation & Operation Manual
F4 F5
SETUP:
NET-COM, NET1
SETUP:
FEEDADJ
Standard Setup Mode
SETUP:
See diagram #2 in printer's
MEDIA
Installation & Operation Manual
SETUP:
PRINT DEFS
SETUP:
NETWORK
F4 F5
Setup
• Press Setup key to exit the Setup Mode.
Warning!
Making selection using DHCP, BOOTP, or RARP and trying to
keep the received IP-address by manual may cause IP-conflict
later on. Instead, contact your network administrator to get a
fixed IP address.
16
The diagram below illustrates the hierachy of setup options that are
added to the Setup Mode when an EasyLAN 100i interface board is
installed in the printer.
Like most other options in the Setup Mode, these options can be
changed using setup strings and files or read using SETUP WRITE
statements.
Select character(s) specifying
new line in data sent from
EasyLAN 100i pcb.
NET-COM,NET1:
Enter
NEW LINE
NETWORK:
Enter
IP SELECTION
F5
First displayed option
indicates current setting.
Use F4 or F5 key to scroll
F4 F5
NEW LINE:
Enter
CR/LF
LF
CR
First displayed option
indicates current setting.
Use F4 or F5 key to scroll
F4 F5
IP SELECTION:
Enter
MANUAL
DHCP
BOOTP
RARP
Read received addresses
Set addresses manually
NETWORK:
IP ADDRESS
F5
NETWORK:
NETMASK
F5
NETWORK:
DEFAULT ROUTER
Intermec EasyLAN 100i – Installation Instructions Ed. 1
Enter
Enter
Enter
IP ADDRESS:
Enter
192.168.1.79
Use keys . and 0–9 to set IP address
manually. Use C-key to erase.
NETMASK:
Enter
255.255.255.0
Use keys . and 0–9 to set netmask
manually. Use C-key to erase.
DEFAULT ROUTER:
Enter
192.168.1.1
Use keys . and 0–9 to set default router
manually. Use C-key to erase.
Enter
Enter
Enter