Exit Selections; Multiple Bar Codes - Intermec ScanImage 1470 User Manual

Or scan one of the following bar codes.
Enter Sequence (see Note)
Note: One or more two digit numbers and Save are required after reading this
programming bar code. Refer to the "General Programming Chart" in Appendix B.

Exit Selections

Save Current Output Sequence Changes
Note: If you want the imager to beep after each bar code is read, please see "Output
Sequence Beeper" earlier in this chapter.

Multiple Bar Codes

Note: This feature does not work when the imager is in Low Power mode.
When this programming selection is turned On, it allows you to read multiple bar codes
with a single pull of the imager's trigger. If you press and hold the trigger, aiming the
imager at a series of bar codes, it reads unique bar codes once, beeping (if turned on) for
each read. When this programming selection is turned Off, the imager will only read the
bar code closest to the aiming beam.
Programming the 147X
*
Default Sequence
Discard Current Output Changes
3
3-73