Kurt DOVELOCK DTR10 Operating Instructions Manual page 8

Dovetail 5 axis vise

Hide thumbs Also See for DOVELOCK DTR10:

Table of Contents

SURFACE MOUNTING THE DTR10

The DTR10 can be located and mounted using a slip fit 1/4 inch center

dowel pin and 10-32 socket head cap screws.

English Mounting:

The DTR10 can be properly located using the 1/4" slip fit dowel

indicated by M in figure 4 above. The DTR10 can be bolted down

using eight 10-32 socket head cap screws indicated in figure 4 above

by L.

JAW POSITIONING

Table of Contents

Introduction .................................................................................................................3

The DTR10 has reversible jaws that allow for more part size variation. See the

Setup Instructions......................................................................................................4

below figure to see the two jaw configuration options and opening

Operating Instructions .........................................................................................5-7

capabilities.

DX6 Parts List ...............................................................................................................8

DX6 Mechanical Drawing ........................................................................................9

Maintenance Schedule....................................................................................10-12

Troubleshooting Tips ............................................................................................. 13

Note: Dimensions below are in inches unless specified.

Fig.5

CAUTION:

Is used when your action or lack of action may cause serious

injury.

OPERATING INSTRUCTIONS

Table of Contents