Mounting The Load; Data Link - Wahlberg Track Runner Series User Manual

Mounting the load

The load on the unit can easily be mounted on the bracket using one or more of the ø12mm holes
[A] as shown below. Remove the four M8 bolts [B] to fully access the mounting bracket.
WARNING! Minimize
slack when using a
secondary suspension
When using a secondary suspension [C] secured behind the mounting bracket, make sure to
minimize the slack in order to avoid collision with the motor gear and the tooth rack behind the
bracket.

Data link

A DMX 512 data link is required in order to control the product via the Wireless DMX transmitter
[A] (ordered separately) or a cable carrier [E] to the Track Runner [B]. The unit have a 5-pin XLR
connector [C] for DMX data output connected to the equipment mounted on the unit [D]. The pin-
out on all connectors is pin 1 = shield, pin 2 = (data -), and pin 3 = (data +). Pins 4 and 5 in the 5-
pin XLR connectors are not used but are available for possible additional data signals as required
by the DMX512-A standard.
A
352-353.805.006
B
C
Wireless link
OR
Cable carrier
15
A
WARNING! Maximum
bolt length behind the
bracket is 40mm
C
E
Date: 2019-07-02
B
D