Setup; Mounting On The Track - Wahlberg Track Runner Series User Manual

Setup

WARNING! Read "Safety Information" on page 2 before installing, powering, operating, or
servicing the product.
WARNING! Only experienced DMX users should operate the product. Do not operate the
product when the mounting bracket is removed.
WARNING! Make sure the load is mounted safely on the unit and do not exceed 20kg (44 lb) as
the specified maximum weight of the load.

Mounting on the track

The Track Runner Series can be mounted from the left or from the right side of the track, and it is
simply done by disconnecting the TRUE1 power input plug [A].
REVERSE
Using the rotary switch [B] to select mode 4 for mounting from the right (forward) of the track as
recommended and shown, or mode 2 for mounting from the left(reverse).
Make sure to pull out both current collectors [C] while sliding the unit half onto the track and apply
external power to the TURE1 input [A], hold it firmly until the motor gear grips the gear rack and
the unit has entirely passed the end point of the track.
Finally remove the external power source from the TRUE1 input [A] and reconnect the TURE1
output with power from the external current collectors.
Select the desired operation mode on the mode switch [B], see page 18 for further details.
352-353.805.006
C
B
WARNING! Always
C
disconnect power from
the track before installing!
14
FORWARD
A
Date: 2019-07-02