Table of Contents
Advertisement
IX.
Calibration
9.1
Probe Calibration
Follow the instructions below to adjust the temperature readout.
These steps are only necessary in the event there is a discrepancy between the display
and measurements taken with an alternate device.
For Example:
A thermometer placed inside the oven with a different measurement than the controller.
Please Note:
Laser probe measurements will be inaccurate without compensating for emissivity.
Refer to your laser probe's user manual.
1. Simultaneously press
0000"
Press
to set LK 0003
Press
three times, you can see Pb, this is temperature offset on single point.
After set of the Pb value，press
Version 1.0
for few seconds until the time position shows "LK
and
to exit.
User Manual
17
Advertisement
Table of Contents
