Table of Contents
Advertisement
T R O U B L E S H O O T I N G
If you suspect that your CD Player is not operating properly, you should check all
the connections carefully. RCA plugs should be fully inserted - a frequent cause of
problems is that RCA plug surrounds do not make proper contact. Below are some
commonly encountered problems with suggestions for possible cure. The list is not
exhaustive: If you have any unresolved problems, please consult your appointed Roksan
dealer or distributor.
SYMPTOM
•
No power.
•
The disc tray
will not close
when a disc is
inserted.
•
Disc inserts,
display does
not show the
number of
tracks and
playing time.
•
Skipping &
mistracking.
•
Excessive hum
•
One channel
inoperative
•
Remote Control
handset
operation
erratic or not
working.
LIKELY CAUSE
•
AC Mains lead not inserted
properly
•
Unit not switched on.
•
Disc not placed properly
in tray
•
Disc is warped.
•
Disc inserted upside down
•
Disc is dirty or scratched
•
Condensation on the laser
lens
•
Dirt on the laser lens.
•
Excessive vibration
•
Disc is dirty or scratched.
•
Connection loose, cable
faulty
•
Interconnect or amplifier
faulty
•
Batteries weak or wrongly
inserted
•
Remote Control signal path
is obstructed
•
Remote Control
transmission angle too
wide
•
Room lighting/sunlight
excessive.
K3 CD Di
SUGGESTED REMEDY
•
Ensure AC mains lead is
fully inserted
•
Switch unit on at front left
underside.
•
Re-place disc properly
•
Discard disc.
•
Re-insert disc
•
Clean disc, discard
scratched disc
•
Let CD Player warm up
and dry out lens
•
Refer to appointed dealer
or service centre
•
DO NOT use CD lens
cleaners.
•
Ensure player is stable and
vibration-free
•
Clean disc, discard
scratched disc.
•
Re-connect plugs, change
interconnect
•
Change lead, try another
line input on amplifier
•
Replace battery, observe
polarity
•
Remove obstruction, move
handset
•
Operate handset in front
of CD Player
•
Darken room.
9
Advertisement
Table of Contents
