Troubleshooting - Roksan Audio K3 User Manual

ROKSAN K3
MANUAL
If you suspect your ROKSAN K3 CD Di Player is not operating properly, first check all the
connections carefully. Pay particular attention to input and output connections. Phono plugs
should be fully inserted- a frequent cause of problems is that Phono plug surrounds do not
make proper contact. On the next page are some commonly encountered problems with
suggestions for possible cure. The list is not exhaustive: If you have any unresolved problems,
please consult ROKSAN or your appointed ROKSAN dealer or distributor.
Symptom
The disc tray will note close
when a disc is inserted
Disc inserts, display does not
show the number of tracks
and playing time
Skipping and mistracking
Excessive hum
One channel inoperative
Remote handset operation
erratic or not working
No sound when digital input
is connected

TROUBLESHOOTING

Likely Cause
Disc is not placed properly
in tray
Disc is warped
Disc inserted upside down
Disc is dirty/scratched
Condensation on the laser
lens
Dirt on the laser lens
Excessive vibration
Disc is dirty or scratched
Connection loose, cable
faulty
Interconnect or amplifier
faulty
Batteries weak or incorrectly
inserted, signal path obstruc-
ted
or angle too wide, bright
light
Incorrect input selection
Suggested Remedy
Replace disc correctly
Discard disc
Re-insert disc label side up
Clean or discard disc
Let player warm up, dry lens
Refer to appointed dealer or
service centre, DO NOT use
CD lens cleaners
Ensure player is stable
Clean or discard disc
Re-connect plugs, change
cables
Change lead, try alternative
line input or amplifier
Replace batteries correctly,
remove obstruction, operate
handset in front of CD player,
darken room
Use right rocker switch to
select correct input