General Information - Intermec EasyCoder 501 SA Installation Instructions Manual

EasyCoder 401/501 – Installation Instruction
PAPER CUTTER KIT

General Information

Note:
Illustrations show an EasyCoder 501 E
printer, but the principles for fitting
the cutter on another printer model
are exactly the same. However, note
that this cutter does not work with any
EasyCoder 401 Linerless or Easy-
Coder 601 printers.
EasyCoder 401/501
Paper Cutter Kit
Installation Instructions
Edition 7, September 1998
Part No. 1-960348-06
This leaflet contains instructions on how to fit a Paper Cutter on an
EasyCoder 401, EasyCoder 501 S, EasyCoder 501 E, or Easy-
Coder 501 SA printer.
The Paper Cutter Kit consists of:
• One cutter unit assembly
• This installation instructions leaflet
The Paper Cutter is power-supplied by the printer and is conse-
quently not dependent on any separate mains supply.
The Paper Cutter is intended to cut through continuous non-
adhesive paper strip or through the backing paper between labels.
It must not be used to cut through any kind of adhesive, which would
stick to the cutting parts and rapidly render the cutter inoperable –
possibly also causing damage to the electric motor.
Maximum paper thickness is 175 m ( 175 grammes/m
normal paper-based materials.
The Paper Cutter replaces the printer's front hatch and can be tilted
down in order to facilitate cleaning and paper load and also to give
access to the optional Memory Card Adapter.
When the Paper Cutter is fitted, it will increase the printer's length
and weight by:
Length .......... : 28 mm
Weight .......... : 1.0 kgs
The rotating cutting edge will cut through the paper approximately
37 mm (1.5") in front of the printer's tear-off edge. The paper feed
setup should be adjusted accordingly, see page 6.
For safety reasons, the cutter must not be operated
when in open position.
Information in this manual is subject to change without prior notice and does
not represent a commitment on the part of Intermec Printer AB.
© Copyright Intermec PTC AB, 1998. All rights reserved. Published in Sweden.
EasyCoder and Fingerprint are registered trademarks of Intermec Technolo-
gies Corp.
Torx is a registered trademark of Camcar Division of Textron Inc.
(1.1")
( 2.2 lbs)
CAUTION!
2
) for
1