Fn Key And Rec Led - Javad MinPad User Manual

FN Key and REC LED

Table 2-1 summarizes FN key functions and REC LED statuses. See PCView
Software Manual for information on setting FN key modes.
• Pressing the FN key for less than one second switches the receiver between
• Pressing the FN key for more than one and less than five seconds will start/
• The REC LED blinks green or orange each time data is written to the
• Pressing the FN key for more than five and less than eight seconds will turn
• After loading new firmware or clearing the receiver's NVRAM, the receiver
www.javad.com
different information modes (normal and extended information), or between
static and dynamic post-processing modes, depending on the receiver's
configuration.
During the first second of pressing the FN key, the REC LED is orange.
stop data recording.
During data recording the REC LED is green or orange.
If the REC LED is red, the receiver has run out of memory, has a hardware
problem, or contains an improper OAF.
internal receiver's memory.
You set the data recording time interval using PCView. See PCView
Software Manual for information on setting this function.
Each time you turn off or on data recording, either a new file opens or data
appends to a particular file.
the baud rate of serial port A to 9600. After about five seconds of pressing
the FN key, the REC LED becomes red. Release the FN key while the REC
LED is red (during the next three seconds).
Pressing the FN key for more than eight seconds has no impact.
checks its internal file system.
During this operation, the REC LED flashes orange, and the file system is
not accessible for CDU (control display unit) applications or for data
recording. This operation may require from fractions of a second to several
K E Y S A N D L E D S

FN Key and REC LED

MinPad User's Manual 2-3