Powering The Lgg100; Connecting The Lgg100 And A Computer; Establishing An Rs232 Cable Connection; Establishing A Pcview Connection - Javad LGG100 Operator's Manual

S E T U P A N D M E A S U R I N G
2

Powering the LGG100

Powering the LGG100

You can power your receiver with an external power source. The appropriate
external power source must provide +9 to +35 V DC to operate the receiver.
Warning: Before connecting the external power source and the
receiver, make sure that the power source matches
the receiver's voltage and current requirements.

Connecting the LGG100 and a Computer

To configure or maintain the LGG100, you need to connect the receiver and a
computer using an RS232 cable, and start PCView.
Once you have established a connection between the receiver and the computer,
you will be able to:
• Configure the receiver and its components
• Send commands to the receiver
• Use FLoader to load new firmware to the receiver
• Use PCView to load OAFs and configuration files to the receiver

Establishing an RS232 Cable Connection

1. Using the RS232 cable, connect the serial port of your computer
2. Press the power button on the computer to turn it on.
3. Continue with steps, described in "Establishing a PCView Connection"

Establishing a PCView Connection

PCView is a software used to manage the various functions of your
receiver.
The full range of PCView configuration and function is outside the scope of
this manual. For more information on any of the procedures in this section
or on PCView, refer to the PCView Software Manual available on the JNS
website (http://www.javad.com).
2-2 LGG100 Operator's Manual
(usually COM1) to the receiver's serial port A.
www.javad.com