Using Terminal Setup - UBI EasyCoder 101 Startup Manual

UBI Shell 4.0 Standard – Startup Manual
TERMINAL SETUP, cont'd.

Using Terminal Setup

The Terminal Setup program is self-instructing by means of prompts.
You can move around in UBI Shell in the same manner as when you
control UBI Shell manually by means of the printer's display,
< Print > key and Headlift.
The Setup part of Terminal Setup follows the same structure as
setup files, see later in this chapter. Comprehensive explanations of
the various setup parameters can be found in the Technical Manual
for the printer model in question.
When you transmit the triple T (TTT) to the printer, the following
message will appear on printer's display:
SETUP FROM
TERMINAL
On the screen of the host, another message will appear:
-----------------------------------------------
Welcome to UBI SHELL v.4.0 in terminal mode
-----------------------------------------------
Answer Y <CR> for Yes, <CR> for No.
----------------
UBI SHELL
SEL. APPLICATION
----------------
(Y / N):
From here on, you can move around in UBI Shell according to the
diagram in the chapter "Using UBI Shell" by answering Y (=Yes)
or N (=No) to the prompts that successively appear on the screen.
Note that the program also accepts the corresponding lowercase
characters, e.g. y and n.
16