Table of Contents
Advertisement
SETUP
Display Setup
1
Set the A-B-C Switch
Locate the A-B-C switch inside the battery compartment. Set the A-B-C switch to A, B or C. You
must select the same letter choices for both the display and the sensor in order for the units to
synchronize.
2
Install or Replace Batteries
1. Remove the battery compartment cover.
2. Insert 3 x AA batteries (not included) into the battery compartment, as shown. Follow the
polarity (+/–) diagram in the battery compartment.
3. Replace the battery cover.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be used for an
extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only
batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak.
DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit
the supply terminals.
A BC
A-B-C
5
1
A-B-C Switch
Set to match
sensor
2
Install Batteries
3 AA Batteries
Advertisement
Table of Contents
