Intermec 751 Supplementary Manual page 2

You can configure the holster to be worn on either side of your
body. The holster can hold a CK31 or 751G with a handle, a CAC
reader, or a serial adapter installed.
Note: The illustrations in this guide show the CK31
for reference. The CK31 and the 751G use the same
shoulder strap, but they use different holsters.
If you do not have a handle attached to your CK31 or 751G, you
can insert it into the holster without having to move the position of
the holster.
To configure the holster, you need this tool:
• #2 Phillips screwdriver
To configure the holster
1 Remove the Phillips screw from the bottom of the mounting bar.
Mounting
bar
Phillips
screw
Holster
2 Slide the holster down and off of the mounting bar.
Mounting
bar
3 Depending on whether you want to wear the holster on the right
or left side, insert the holster on the mounting bar according to
the next illustration.
To wear holster
on right side
4 Replace the screw in the bottom of the mounting bar.
Holster
To wear holster
on left side