Advertisement
Quick Links
1
Start Here
Quickstart Guide - AyrMesh
Turn over for one-page "Ultra �uickStart" Instructions.
Please visit http://support.ayrstone.com for detailed instructions,
videos, slide shows, and a troubleshooting guide
Check the contents of the box:
- Hub2T
- Antenna
- Mounting Bracket
- Power Supply
- Power Cord
- (2) Ethernet Cables
- (2) Zip Ties (not shown)
- (2) Hose clamps (not shown)
- Coaxial sealing tape (not shown)
POE
LAN
Write down the MAC address
of your Hub, write it here, and
keep it in a safe place:
00:C0:
Use a computer connected
to the same router to which
you're connecting the Hub!
NOTE: All Hubs must be "initialized" by connecting
to AyrMesh.com to download their con�guration
information before use.
®
Hub2T
.
MAC Address
If you don't have one,
sign up for an account
on AyrMesh.com
®
®
Advertisement
Related Manuals for AYRSTONE AyrMesh Hub2T
Summary of Contents for AYRSTONE AyrMesh Hub2T
- Page 1 ® Quickstart Guide - AyrMesh Hub2T Turn over for one-page "Ultra �uickStart" Instructions. Please visit http://support.ayrstone.com for detailed instructions, videos, slide shows, and a troubleshooting guide Check the contents of the box: Write down the MAC address of your Hub, write it here, and...
- Page 2 Assemble the Hub and attach to router Unscrew the bottom of the Hub: Screw the antenna gently into the bracket... Plug an Ethernet cable into the port on the hub - slide in until it clicks in place ...and then screw the Hub onto the antenna (�ngers only, no tools)
-
Page 3: Finish The Installation
Make sure the Hub is working The signal lights (4 top lights) will start out "running" from bottom to top. When the Hub has checked in to AyrMesh.com, just the top signal light will be on. Hub is Checking In It usually takes about 1-2 minutes for the Hub to check in and show up on AyrMesh.com, but sometimes it can take a little longer. - Page 4 Signal Lights on the Hub Gateway Hubs have the following Top Signal light - green lights on: Third Signal light - green Top Signal light Second Signal light - orange Ethernet activity light First Signal light - red Power light Ethernet activity light - blue Power light - blue Remote Hubs use the signal lights to show the signal strength to the nearest Hub.
-
Page 5: Troubleshooting
NOTE: To prevent water damage, make sure the Hub is mounted with its antenna pointing straight up and that the Ethernet cable has a "drip loop" where it enters any building. Drip Loop See http://ayrstone.com/support for additional information, hints, and troubleshooting tips. - Page 6 These directions are minimized for more knowledgeable/experienced installers. For the "regular" �uickstart instructions, turn these directions over. For more detailed instructions, please see https://support/ayrstone.com GET READY: Write down the MAC address of the Hub and put it someplace safe. If you haven't already, create an account on AyrMesh.com from a computer connected to the same router that the Hub will be connected to.
Need help?
Do you have a question about the AyrMesh Hub2T and is the answer not in the manual?
Questions and answers