Advertisement

Ayrstone AyrMesh
Bridge Setup
Quickstart Guide
Ayrstone.com
Check the contents of the box:
• AyrMesh Bridge (2 radios)
• Power Supplies (2)
• Power Cords (2)
• Ethernet Cables (2)
• Zip Ties (2 - not shown)
POE
LAN
POE
LAN
1
TM
NOTE: The AyrMesh Bridge consists of
two radios - the "Gateway" radio, which is
connected to your existing network, and the
"Remote" radio, which is connected to the
device you want connected to your network
Write down the MAC
addresses of your AyrMesh
Bridge radios - keep them in
a safe place
If you don't have one,
sign up for an account
on AyrMesh.com
Use a computer connected
to the same router as your
AyrMesh Bridge!

Start Here

Quickstart Guide-
AyrMesh Bridge
Visit Ayrstone.com/support
for detailed instructions,
videos, slide shows, and a
MAC Address
MAC - 11:22:33:44:55:66

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AyrMesh and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for AYRSTONE AyrMesh

  • Page 1 Quickstart Guide videos, slide shows, and a Ayrstone.com troubleshooting guide. NOTE: The AyrMesh Bridge consists of two radios - the "Gateway" radio, which is connected to your existing network, and the "Remote" radio, which is connected to the device you want connected to your network...
  • Page 2 "POE" router NOTE: Each Bridge radio must be "initialized" by connecting it to your router until it shows up in your AyrMesh.com account. This usually takes 5 minutes, but may take longer. Use another Ethernet cable to connect the...
  • Page 3 (right 4 lights) will start out "running" from left to right. When the Bridge half has checked in to AyrMesh.com, only the rightmost signal light will be on. The Bridge is most easily mounted to a pole with a zip-tie, as shown.
  • Page 4 Troubleshooting - Ethernet Light does not come on, or Bridge does not appear in router's DHCP table, or bridge radio never checks in to AyrMesh.com See http://ayrstone.com/support - Check all cables between router and Bridge radio for additional information, hints, and troubleshooting tips.

Table of Contents