Advertisement
1
Start Here
Quickstart Guide AyrMesh
Check Contents of the box:
1. Cab Hub 2
2. Antennae (2)
3. Vehicle power cable
4. Power Supply
5. Wall Power Cord
6. (2) Ethernet Cables
7. (2) Zip Ties (not shown)
1
4
5
2
3
6
Cab Hub 2
®
Remove the door, write down the MAC address
ofyour Hub, write it here, and keep it with these
directions in a safe place:
00:C0:
MAC Address
Ifyou don't have an account on AyrMesh.com,
create one now using a device connected to your
network (not a cellphone unless it's connected to
your router via WiFi):
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AYRSTONE AyrMesh Cab Hub 2
Summary of Contents for AYRSTONE AyrMesh Cab Hub 2
- Page 1 Start Here Quickstart Guide AyrMesh Cab Hub 2 ® Remove the door, write down the MAC address Check Contents of the box: ofyour Hub, write it here, and keep it with these directions in a safe place: 00:C0: 1. Cab Hub 2 2.
- Page 2 Assemble the Hub and connect to router Plug an Ethernet cable into the left-hand port Screw the antennae (marked "LAN PoE IN") on the Hub - slide in gently onto the until it clicks in place: threads on the Hub - finger-tight (no tools): DO NOT FORCE...
- Page 3 Make Sure Hub is Working It usually takes about 1-2 minutes for the Hub to The signal lights (3 top lights) will start out check in and show up on AyrMesh.com, but "running" from bottom to top (or left to right if sometimes it takes a bit longer.
- Page 4 Finish the installation continued We have had very good luck with RAM mounts on the cab rails inside tractors, combines, and sprayers. We have used the combination ofthe RAM Tough-Claw Small Clamp Base with Ball, Part # RAP-B-400U (you may need a different part, like a bigger clamp base to connect to a ROPS bar), combined with one ofthe double-socket arms like RAM-B-201U (you may want a shorter or longer arm) and an AMPS pattern Ball Base...
- Page 5 Signal lights on the Hub Remote Hubs like the Cab Hub have the Power light on steady, the WiFi activity light flashing, Top Signal light - green and the signal lights on indicating the signal Second Signal light - orange strength to the nearest Hub: First Signal light - red •...
- Page 6 DHCP reservations instead to avoid IP address conflicts. - Check for network loops - commonly caused by devices with multiple ways to connect to the network (e.g. printers or cameras with both Ethernet and WiFi) See http://support.ayrstone.com for additional information, hints, and troubleshooting tips.
Need help?
Do you have a question about the AyrMesh Cab Hub 2 and is the answer not in the manual?
Questions and answers