AYRSTONE AyrMesh IndoorHub Quick Start Manual

Advertisement

1
Start Here
Quickstart Guide - AyrMesh
Turn over for one-page "Ultra �uickStart" Instructions.
Please visit http://support.ayrstone.com for detailed instructions,
videos, slide shows, and a troubleshooting guide
AyrMesh IndoorHubs can be used two ways: as a Gateway, which is a simple access
point, and as a Remote, which acts as a wireless extender for an IndoorHub Gateway.
Check the contents of the box:
- IndoorHub
- USB Power Supply
- USB micro cable
- Ethernet Cable
®
.
Write down the MAC address
of your IndoorHub, write it here,
and keep it in a safe place:
0C:EF:
If you don't have an account, sign up for one
on AyrMesh.com
IndoorHub
(Underside)
Use a computer connected
to the same port you're
using for the IndoorHub!
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AyrMesh IndoorHub and is the answer not in the manual?

Questions and answers

Summary of Contents for AYRSTONE AyrMesh IndoorHub

  • Page 1 Quickstart Guide - AyrMesh IndoorHub Turn over for one-page "Ultra �uickStart" Instructions. Please visit http://support.ayrstone.com for detailed instructions, videos, slide shows, and a troubleshooting guide AyrMesh IndoorHubs can be used two ways: as a Gateway, which is a simple access point, and as a Remote, which acts as a wireless extender for an IndoorHub Gateway.
  • Page 2 Assemble and Connect Connect the "micro" side of the USB cable to the IndoorHub: Connect the "regular" side of the USB cable to the power supply: ...And then connect the IndoorHub to your network with an Ethernet cable (use either port on the IndoorHub): Plug the power supply into the wall and wait for the IndoorHub to boot: Wait for the light on the IndoorHub...
  • Page 3 IndoorHubs in a relatively small area will interfere with each other. Note that IndoorHubs will only mesh with other IndoorHubs, not with the Outdoor Hubs - to use a Remote IndoorHub, you must have a working Gateway IndoorHub. See http://ayrstone.com/support for additional information, hints, and troubleshooting tips.
  • Page 4 These directions are minimized for more knowledgeable/experienced installers. For the "regular" �uickstart instructions, turn these directions over. For more detailed instructions, please see https://support/ayrstone.com GET READY: Write down the MAC address of the IndoorHub and put it someplace safe. If you haven't already, create an account on AyrMesh.com. Note: if you don't already have AyrMesh devices, create the account from a computer connected to the same router you'll connect the IndoorHub to.

Table of Contents