Intermec 5020 Instructions

39
nugget
243X and 502X Holster Instructions
You can use the holster (Part No. 072366) to carry your Trakker Antares
terminal or 502X Hand-Held Data Collection PC at your side.
The holster ships ready to be worn
on either side. You can also use the
three mounting loops to configure
the holster to accommodate a 243X
or 502X with a handle.
These instructions describe
how to configure the holster to
accommodate a 243X or 502X with
a handle and how to put on the
holster. Before using the holster,
please read these instructions
thoroughly and retain them for
future reference.
To configure the holster for a 243X or 502X with a handle
1. Remove the Phillips screw from
the top of the mounting bar.
2. Slide the holster cup up and off of
the mounting bar.
3. Insert the mounting bar into a
different mounting loop on the
holster cup.
Use the loop to the right of the
original loop to wear the holster
on the right, and use the loop to
the left of the original loop to wear
the holster on the left.
4. Replace the screw in the top of the
mounting bar and tighten.
5. Slide the mounting assembly to
the appropriate side of the waist
belt.
To learn how to put on the holster,
continue with the next procedure.
®
243X
Waist belt
buckle
243X5020I001.eps
Leg strap
Mounting
1
bar
Phillips
screw
Holster
cup
2
Mounting
bar
Mounting
loop
(3 places)
243X5020I002.eps
243X and 502X Holster Instructions
You can use the holster (Part No. 072366) to carry your Trakker Antares
terminal or 502X Hand-Held Data Collection PC at your side.
The holster ships ready to be worn
on either side. You can also use the
three mounting loops to configure
the holster to accommodate a 243X
or 502X with a handle.
These instructions describe
how to configure the holster to
accommodate a 243X or 502X with
a handle and how to put on the
holster. Before using the holster,
please read these instructions
thoroughly and retain them for
future reference.
To configure the holster for a 243X or 502X with a handle
1. Remove the Phillips screw from
the top of the mounting bar.
2. Slide the holster cup up and off of
the mounting bar.
3. Insert the mounting bar into a
different mounting loop on the
holster cup.
Use the loop to the right of the
original loop to wear the holster
on the right, and use the loop to
the left of the original loop to wear
the holster on the left.
4. Replace the screw in the top of the
mounting bar and tighten.
5. Slide the mounting assembly to
the appropriate side of the waist
belt.
To learn how to put on the holster,
continue with the next procedure.
®
243X
Waist belt
buckle
243X5020I001.eps
Leg strap
Mounting
1
bar
Phillips
screw
Holster
cup
2
Mounting
bar
Mounting
loop
(3 places)
243X5020I002.eps