Ethernet Interfaces - Bosch Rexroth IndraControl VPP 21.2 Project Planning Manual

Project Planning Manual | Rexroth IndraControl VPP 21.2
7.3.6

Ethernet Interfaces

Ethernet – Network connection
Fig.7-6: USB interfaces
Pin Function
1 USB power supply (max. 500 mA)
2 Data -
3 Data +
4 USB ground
The VPP 21 can be connected with Ethernet networks via the interfaces Eth.1
and Eth.2.
RJ45 female connector, 8-pin
Type:
Cable length:
Cable type:
Transmission rate:
Fig.7-7: Ethernet Interface
The driver configuration of the network connection can be called up in the task
bar or in the "Control Panel" with icon "Network Board". Here you can set among
other values, if the data transmission shall occur with 10 Mbits/s and/or with
100 Mbits/s.
Please observe that the network board of the outstation has to be
able to process the same data transmission rate.
Electric Drives | Bosch Rexroth AG
and Controls
Ethernet 10Base T / 100Base X
100 m max.
Shielded, twisted pair
10 or 100 Mbits/s
43/65
VPP 21-Box