Table of Contents
Advertisement
Project Planning Manual | Rexroth IndraControl VPP 21.2
2
Important Instructions on Use
2.1
Appropriate Use
2.1.1
Introduction
WARNING
2.1.2
Areas of Use and Application
Rexroth products represent state-of-the-art developments and manufacturing.
They are tested prior to delivery to ensure operating safety and reliability.
Physical and property damage due to the inappropriate use of products!
The products are designed for their use within the industrial environment and
may therefore only be used for the intended purpose. If the use is inappropriate,
situations causing physical damage as well as property damage can occur.
Rexroth disclaims as manufacturer any warranty, liability or for
damages occurring due to inappropriate use of the products. Fur‐
thermore, Rexroth is not paying any compensation. The user is
responsible for any risks resulting from the products not being used
as intended.
Before using Rexroth products, the following pre-requisites must be fulfilled to
ensure an appropriate use of the products:
●
Anyone handling one of the Rexroth products in any way has to read and
understand the respective safety instructions as well as the instructions
on the appropriate use.
●
Hardware products have to remain in their original state, in other words,
no modification regarding the design are allowed. Software products may
not be decompiled and their source codes may not be modified.
●
Damaged or faulty products are not to be implemented or put into opera‐
tion.
●
It is to be ensured that the corresponding products are installed according
to the specifications of the documentation.
hand-held terminal VPP 21.2 of Rexroth are machine operating fields devel‐
oped for control tasks. Typical areas of application of the hand-held terminal
VPP 21.2 are:
●
Lathes
●
Milling machines
●
Processing machine
It can be necessary to connect additional sensors and actuators to control and
monitor the hand-held terminal VPP 21.2.
The hand-held terminal VPP 21.2may only be used with the acces‐
sories and add-on components specified in this documentation.
Components that are not named explicitly may neither be mounted
nor connected. Same is applicable for cables and wires.
Operation my only be carried out in the configurations and combi‐
nations of the components specified and with the software and
firmware determined in the respective functional description.
Each drive control device has to be programmed before commissioning so that
the motor carries out the specific functions for the application.
Electric Drives
| Bosch Rexroth AG
and Controls
Important Instructions on Use
5/65
Advertisement
Table of Contents
