Power Requirements; Environmental Requirements - Kodak Desktop 3 Microfilmer User Manual

Power requirements

Environmental requirements

8
Safety Check — Upon completion of any service or repairs to the unit,
ask the service technician to perform safety checks to determine that the
unit is in proper operating condition.
Moving the Microfilmer  Do not attempt to move the microfilm by
grasping anything inside the cover to use as leverage. Damage to the
microfilmer, or lost images, could occur.
The Kodak Desktop 3 Microfilmer can operate on the following power
supplies:
• 100 volts ac, 50 Hz or 60 Hz, 3.5 amps
• 120 volts ac, 50 Hz or 60 Hz, 3.0 amps
• 220 volts ac, 50 Hz or 60 Hz, 1.5 amps
• 240 volts ac, 50 Hz or 60 Hz, 1.5 amps
• 230 volts ac, 50 Hz or 60 Hz, 1.5 amps
A standard three-prong, grounded power outlet is required for operation
within the United States and Canada.
CAUTION: The Desktop 3 Microfilmer is set at the factory for 120
volts ac operation in the United States and Canada. If
you require a different power configuration, contact your
Equipment Services Representative for Kodak products.
Electrical current requirements can vary from country to
country, depending upon operating voltage.
The Kodak Desktop 3 Microfilmer can be operated in a typical office
environment that is maintained at 59°-86°F (15°-30°C). The acceptable
relative humidity range is 15-76 percent. Total heat dissipation is
approximately 1024 BTUs per hour (300 watts/hour).
A-61036 July 2000