Kogan LCDP30 Installation Instructions
Kogan LCDP30 Installation Instructions

Kogan LCDP30 Installation Instructions

Led/lcd/plasma wall mount

Advertisement

3.1
4.1
C
D
E
G
H
F
I
H
4.2
4
Hang TV on wall
mount

Adjusting TV

02
J
+10°/-10°
49mm
M6
M4
M8
FLAT BACK
ROUND BACK
Attach bracket to
TV
Maximum 800mm
LCDP30
Installation
Instruction
INSET HOLES
CABLES
LED/LCD/PLASMA
WALL MOUNT
3
IMPORTANT
SAFETY INSTRUCTOPNS
Please read through these instructions
completely to be sure you're comfortable
with this easy install process. Also check
your TV owner's manual to see if there are
any special requirements for mounting
your TV. If you do not understand these
instructions or have doubts about the
safety of the installation, assembly or use
of this product, contact your Customer
Service.
CAUTION: Avoid potential personal injuries
and property damage!
● This product is designed for use in solid
concrete, and concrete block walls - DO
NOT install into drywall alone!!
● The wall must be capable of supporting
five times the weight of the TV and
mount combined.
● Do not use this product for any purpose
not explicitly specified by manufacturer.
● Manufacturer is not responsible for
damage or injury caused by incorrect
assembly or use.
● This wall mount is intended for use with
television that does not exceed the
maximum weight capacity designated.
Using this mount with products heavier
than the maximum weight indicated may
result in instability causing possible injury.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LCDP30 and is the answer not in the manual?

Questions and answers

Summary of Contents for Kogan LCDP30

  • Page 1 LCDP30 Installation Instruction FLAT BACK ROUND BACK INSET HOLES CABLES LED/LCD/PLASMA WALL MOUNT Hang TV on wall Attach bracket to mount IMPORTANT SAFETY INSTRUCTOPNS Please read through these instructions completely to be sure you’re comfortable with this easy install process. Also check your TV owner’s manual to see if there are...
  • Page 2 Parts for assembly preparation Masonry Hammer Wrench Pencil Drill Bit Wall plate x1 Bracket x2 Hardware 5.5 mm (7/32 in.) Stud Wood Screw Electric Socket Finder Drill Bit driver Drill Wrench 8mm washer x4 M8x16mm x4 M6x20mm x4 M4x20mm x4 ST6x50 Lag Bolts x6 Plastic wall Anchor x6 Tools required...

Table of Contents