Advertisement
Quick Links
Advertisement
Related Manuals for Kogan KATVSFWS43A
Summary of Contents for Kogan KATVSFWS43A
- Page 1 MOBILE TV FLOOR STAND (SUITABLE FOR 17-43" TVS) KATVSFWS43A...
-
Page 2: Safety And Warnings
SAFETY & WARNINGS Read the entire user guide before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, contact your local distributor for assistance. Use with products heavier than the rated weights indicated may result in instability causing possible injury. - Page 3 COMPONENTS A (x1) B (x1) C Base (x1) D Media Shelf (x1) E Mount Connector (x1) F VESA Mount (x1) G Shelf Bracket (x1) H Casters (x5) I VESA Mount Extension Arms (x2) J VESA Mount K Thumb Screws (x1) L M5 Nuts (x8) Extension Arms (x2) M M4x6 Screw (x20)
- Page 4 S D8 Washer (x4) T Spacer (x8) U 3mm Allen Key (x1) V 5mm Allen Key (x1) W 6mm Allen Key (x1) X 8mm Open Spanner (x1) M-A M4x12 Screw (x4) M-B M5x12 Screw (x4) M-C D5 Washer (x4)
- Page 5 ASSEMBLY Step 1:...
- Page 6 Step 2: Note: 2 people recommended for this step.
- Page 7 Step 3:...
- Page 8 Step 4: Attach the media shelf (D) to the stand assembly using the shelf bracket (G) and 2 M4x50 Screws (P).
- Page 9 Step 5: Attach the mount connector (E) to the stand assembly. Secure the mount connector at the desired height by tightening the hex screw using the 6mm Allen Key (W).
- Page 10 Step 6: Extension arms (I) & (J) are not required. Attach the Extension arms (I) & (J) to the bracket (F) using the bolt and nut set (N, L), tightening with the included spanner (X). 75x75 100x100 100x200 200x200 200mm 100mm 75mm 200mm...
- Page 11 VESA: 200 x 200...
- Page 12 Step 7a: 75x75, 100x100 • A (M-A, M- B, Q) (depending on required length). • Check if spacers (M-C, S) are required to ensure correct length of screw, as per the below image. Failure to follow this step may result in damage to your TV or wall mount. Too Long Too Short...
- Page 13 Step 7b: 100x200, 200x200 • and secure using supplied screws (M-A, M-B, Q, R) (depending on required length). • Check if spacers (M-C, S, T) are required to ensure correct length of screw, as per the below image. Failure to follow this step may result in damage to your TV or wall mount.
- Page 14 Step 8: • Hook the TV with brackets installed onto the floor mount. 2 people should carry the TV to prevent damage. • Once in place, fasten the thumbs screws (K) to secure the bracket. •...
- Page 15 Step 9: To adjust the TV vertical angle, loosen the screw and move the bracket into the desired position before retightening. Do not overtighten. Note: If the display does not stop at your desired position, adjust the screws as shown.
- Page 16 Need more information?