Bosch Rexroth Tightening System 350 Manual page 415

3 608 878 300
MID 0403 Deactivate automatic/manual mode
Sent by:
The subscription to the change in operating mode (Logon automatic/manual mode,
Note: -
Revision:
Data field:
Possible response
Command accepted
Command error
MID 0404
Selection automatic/manual mode
Sent by:
The operating mode is changed.
Note: -
Revision:
Data field:
0: automatic mode
1: manual mode
Possible response
Command accepted
MID 0410
AutoDisable setting request
Sent by:
This command requests the setting of the automatic disabling function. It is set in the BS350:
– Compact system: OK/NOK counter configuration, option Block nutrunner
– KE: Tightening cell data/Open Protocol, option Disable application automatically
Note:
Revision:
Data field:
Possible response
AutoDisable setting response
MID 0411
AutoDisable setting response
Sent by:
The setting is transmitted.
Note: -
Revision:
Data field:
Possible response
Command accepted
1) This message is supported from version V2.200 of the Rexroth Tightening System 350.
2) This message is supported from version V2.300 of the Rexroth Tightening System 350.
System 350 | 3 608 878 300/2019-03
superordinate computer
001 (supported by Rexroth OP and Rexroth OP-Ford) and Rexroth OP-BMW)
is empty, 0 bytes
superordinate computer
001 (supported by Rexroth OP and Rexroth OP-Ford) and Rexroth OP-BMW)
Operating mode, 1 byte. The operating mode is identified by one ASCII character and can be as follows:
2)
superordinate computer
-
001 (Rexroth OP-Ford)
is empty, 0 bytes
2))
Tightening controller
001 (Rexroth OP-Ford)
Data 4 bytes
Tightening Technology | Bosch Rexroth AG 415/641
MID Error no. Comment
0005 –
0004 83 Activation for automatic/manual mode not available
1)
MID Error no. Comment
0005 –
MID Error no. Comment
0411 –
MID Error no. Comment
0005 –
MID 0400) is reset.