Bosch Rexroth Tightening System 350 Manual page 362

362/641 Bosch Rexroth AG | Tightening Technology
Table 6–91:
Parameter
cycles
Date of the last check
Serial number
Data length revision 001
MID 0041 revision 002-1, only Rexroth OP
Table 6–92:
Parameter
This revision includes the information from revision 001 and the following additional information:
Calibration value
Date of the last check
MID 0041 revision 001
Comments
– ErgoSpin: cycles
– Tightening spindle: cycles for the primary transducer
The value consists of ten ASCII characters.
ID
Value range
Presetting
Example:
cycles
Value
Date output in the format YYYY-MM-DD:HH:MM:SS.
The value consists of 19 ASCII characters.
ID
Value range
Presetting
Example (ErgoSpin):
Date of the last check
Value
ErgoSpin/tightening spindle: SE/CS serial number
The value consists of ten ASCII characters.
ID
Value range
Presetting
Example:
Serial number
Value
MID 0041 revision 002-1
Comments
The value consists of four ASCII characters.
ID
Fixed value
Date output in the format YYYY-MM-DD:HH:MM:SS.
The value consists of 19 ASCII characters.
ID
Value range
Presetting
Example (ErgoSpin):
Date of the last check
Value
02
0x20 – 0x7F
-
5467
0000005467
03
0 – 9, "-" and ":"
-
1/12/2009:2:43:57 PM
1/12/2009:2:43:57 PM
04
0000000000 – 9999999999
-
476547
476547
05
000000
06
0 – 9, "-" and ":"
-
1/12/2009:2:43:57 PM
1/12/2009:2:43:57 PM
System 350 | 3 608 878 300/2019-03
3 608 878 300
Bytes
2
10
2
19
2
10
61
Bytes
2
6
2
19