Ignition Sense Cable Installation - Motorola MTM800 Installation Manual

INSTALLATION

Ignition Sense Cable Installation

Number
HKN9327 Ignition Sense Cable with fuse 4 A
6580283E02 Fuse 4 A for Ignition Sense Cable
The HKN9327 Ignition Sense Cable allows the terminal to be turned on and off by the vehicle
ignition switch.
The ignition sense cable kit contains a thin cable and a fuse holder. To install the cable, carry out the
following steps.
1. Plug the lead of the Ignition Sense Cable with the crimped on terminal into #10 socket of the
accessory plug.
2. Route and secure the cable with attached tie wrap.
3. Connect the other lead of the accessory cable to the ignition switch of the vehicle.
4. Insert the fuse into the fuse holder and close the cover.
MTM800 Enhanced Mobile Terminal Installation Manual
Table 2 Ignition Sense Cable
Description
In cases of blown fuses, replace ONLY with those of
identical value.
NEVER insert ones of different values.
Ensure that the fuse is removed during cable installation.
15
16
Figure 3 Accessory Connector with Ignition Sense Cable
If the ignition line is not used, it needs to be grounded.
Interference can cause radio to hang.
Ignition Sense Cable, Length: 3 m
1
2
10
Rating
31