Advertisement
Kaiterra
C. Connect to the device
Open the network settings on your computer or smartphone and look for the Wi-Fi network that starts
with "Kaiterra". Connect to that network.
On the Kaiterra Enterprise Configuration Tool, you can enter a name for the device (e.g. the location of the
device or the serial number) and a project tag. This will provide easy identification and filtering in the
configuration history page later on to help you quickly connect the device to the Kaiterra dashboard.
Enter the Modbus settings details to the applicable fields on the Configuration Tool following the
instructions below:
Setting Device Address
You can customize your device address in the Kaiterra Enterprise Configuration Tool. The device
address is used to identify the device in the system, so please make sure each device is given a unique
device address.
Customize your device address by entering an address from 1 to 247 in the address field in the
Kaiterra Enterprise Configuration Tool. It is recommended to set your device address onsite during or
right after installation, so that you can keep track of the device installed and the corresponding device
address.
Setting Parity Type
You can configure Parity to be odd, even, or none by selecting from the drop down menu in the
Kaiterra Enterprise Configuration Tool. The default setting for Parity is "even".
If your Modbus network does not use parity checking, select "none". Please consult your Modbus
network admin or BMS admin to confirm the parity type of your local network. Please note that all
devices in the same network should be set to the same parity type.
www.kaiterra.com
Advertisement
