Hyundai SF7A214 Manual page 16

INSTRUCTION
the nylon line from the vent in the spoolholder (pos. 1), pull hard, unwind the line
as far as the next vent and insert it into this vent (pos. 2).
- P r o f e s s i o n a l c u t t i n g h e a d w i t h m a n u a l r e e l : Ch e c k
t h a t t h e c o r d t o u c h e s o r p a s s e s t h e e d g e o f t h e g u a r d .
If the cord is shor ter than the required length, hold the reel with
one hand, and pull the cover with the other, causing it to rotate
space in an anti-clockwise direction(1-2). Pull the cords outwards
and check their length(3). If necessary repeat the operation (fig.D).
- Cutting head with automatic spool unit: check that the nylon line touches or goes
beyond the edge of the guard. If the nylon line does not reach the required length,
press the button with one finger and at the same time pull on the line (fig. D).
For subsequent adjustments when the machine is in use, gently tap the spool button
against the ground whilst continuing to run the machine(fig. L). The length of the
nylon line will thus be automatically adjusted.
- Cutting head with professional automatic spool: make sure that the cutting line
touches or extends beyond the edge of the guard. If the cutting line is not the required
length, press the knob all the way down with the palm of your hand and rotate it
clockwise by one click, then pull out the line (fig. D). For subsequent adjustments
during machine operation, run the motor at full speed and hit the head on the ground
so that the knob is pressed and allows the line to unreel.
- Cutting head with disposable line: check that the line is correctly fixed to the spool
and that is protrudes by at least 2 cm from the spool. Otherwise, the disposable
line must be replaced in the manner indicated in the drawing (fig. I).
- Dual-line cutting head: hold the head tight, loosen the knob and feed the lines
through the appropriate slots so that they extend the same length at both ends, then
re-tighten (fig. D).
- Cutting head with 'Full-Automatic' spool: make sure that the cutting line touches
or extends beyond the edge of the guard. If the cutting line does not reach the
required length, start the machine (as described below) two or three times without
cutting the grass: this will automatically adjust the length of the line.
- Cutting head with plastic blades: make sure that the blade holding disk is properly
fastened.
- Cutting head with star-shaped metal blade (if provided): make sure the blade
is securely fastened before starting the machine.
2) Plug the machine into the extension cable socket and connect to the cable coupler
( fig. E). Take hold of the machine firmly and, without bringing it into contact with
the grass to be cut, press the switch on the top handgrip. Run the machine for a
few seconds without cutting thus adjusting the line.
Some machines are fitted with a device to limit the noise output that
starts the motor a few seconds after the switch is activated.
3) The machines provided with lower adjustable body allow vertical cutting of the grass.
To adjust the lower body, proceed as follows as shown in fig. M (where fitted):
- disconnect the power supply
- hold the lower part of the machine with one hand and the central tube with the
other hand
- push them against each other and rotate the lower part by 180O (1)
- release the lower part (2) so as to cut the grass vertically (3)
ENGLISH
17
16