Initial Setup; General Operation - Bush VL19HDLED Instruction Manual

Getting to know your TV
You'll be up and running in no time

Initial setup

1. Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to the
RF (75Ω) socket at the bottom of your TV.
2. Connect the mains cable to the mains socket after
you have completed all the connections.
3. With power cord plug connected to the mains power
socket and TV in 'Standby' mode.At this stage, the TV
switches to standby mode. The red LED indicator will
illuminate on the front panel of the TV.
4. In standby mode, press the " " button on the right of
the TV or the " " button on the remote control to turn
the TV on. The red LED indicator will turn blue.
5. The first time you turn the TV on, it will go straight
into First Time Setup menu. Press the buttons to
navigate the menu and change the settings.
First Time Setup
OSD Language
Mode Setting
Country
Tuner Type
Auto Scan
LCN
Auto Channel Update
Start
Move Adjust
OSD Language
Selects your desired language to be displayed on the
menu. The default on-screen menu language is set as
English.
Mode Setting
Selects your desired mode setting.
• Home Mode: Viewing at home.
• Store Mode: For store demo, the brightness is higher
than home mode.
Country
Selects the country where you will operate the TV. The
default country is set as UK.
Tuner Type
Select Tuner Type: Cable / Antenna.
Auto Scan
Selects the auto scan type: DTV+ATV / DTV /ATV.
LCN
Select LCN Type On or Off.
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 604 0105.
English
Home Mode
UK
Cable
DTV+ATV
Off
Off
MENU: Return EXIT: Exit
Auto Channel Update
Select Auto Channel Update Type On or Off.
Start
Press the OK button to start auto tuning. Auto Scan will
commence. The display will show the progress of the
tuning and the number of channels found.
Auto Scan
Scanning CH34
Digital Channels Found:
DTV :10 Radio :0 Data:0
Analog Channels Found: 0
6. If you want to skip the DTV tuning, press the MENU
button to interrupt the tuning half way. You will then go
straight to ATV tuning. You may repeat the above step if
you also want to skip the ATV tuning.

General operation

Press the INPUT button on the remote control and
select DTV to switch the TV to Digital Terrestrial
Television Broadcasting.
Information Banner
Whenever you change channel using the CH+/CH-
buttons or the number buttons, the TV displays the
broadcast picture along with an information banner
on the top left of the screen (available only in DTV/ATV
mode).
The information banner can be displayed a any time
while watching TV by pressing the INFO button on the
remote control.
Getting to know your TV
MENU: Skip EXIT: Exit
17