Page 1
Instruction N A R R O W C R O W N manual STAPLER M O D E L NS100A IMPORTA N T Please make certain that the person who is To learn more about Porter-Cable to use this equipment carefully reads and...
: READ AND FOLLOW ALL INSTRUCTIONS. There are certain applications for which this tool was designed. Porter-Cable strongly recommends that this tool NOT be modified and/or used for any application other than for which it was designed. If you have any questions r e l a t i v e t o i ts application DO NOT use the tool until you have written Porter- Cable and we have advised you.
Page 3
SAFETY W ARNING LABEL. I f l a b e l i s missing, damaged or unreadable, conta c t your Porter-Cable Service Center for a replacement. Fig. 6. 1 2 . O N LY USE PARTS, FASTENERS, A N D ACCESSORIES recommended by Porter- Cable.
Page 4
Fig. 10 Fig. 11 1 6 . REMOVE FINGER FROM TRIGGER Fig. 12 when not driving fasteners. Never carry tool w i t h f i n g e r o n t r i g g e r : t o o l m a y f i r e a f a s t e n e r if safety is bumped while trigger is depressed.
Always connect tool to air supply before loading fasteners. Do not load fasteners with trigger or safety depressed. Only use approved Porter-Cable fasteners (see ACCESSORIES). Always wear Z87 approved safety glasses, and hearing protection when preparing or operating the tool.
USING THE TO O L Complete all steps of PREPARING THE TO O L before using the tool. To f i r e , g r i p t o o l f i r m l y, position nose of tool onto work surface, push forward on tool to depress safety, and squeeze trigger to fire a fastener.
Page 8
Fig. 20 Fig. 21 CLEARING A JAMMED FASTENER CAUTION: Disconnect tool from air supply. Open magazine and remove any remaining fasteners. CAUTION: Remove fasteners from tool before opening the fastener guide plate. Fasteners are under pressure and may shoot out of magazine which could cause injury.
I f t o o l i s u s e d w i t h o u t a n i n - l i n e o i l e r : p l a c e 5...
Page 10
ONE YEAR WA R R A N T Y Porter-Cable warrants i ts n a i l i n g a n d s tapling tools for a period of one year from the date of original purchase. We w i l l r e pair or replace at our option, any pa r t o r pa r ts of the product and accessories covered under this warranty which, after examination, proves to be defective in workmanship or material during the warranty period.
Page 11
Porter-Cable products should be obtained by contacting any Porter-Cable Distributor, Authorized Service Center, o r Porter-Cable Factory Service Center. If you do not have access to any of these, call 888-848-5175 and you will be directed to the nearest Porter-Cable Factory Service Center.