The Information contained herein shall not be copied, transferred, conveyed, or displayed in any manner that would violate its proprietary nature without the express written permission of Bray International, Inc. that would violate its proprietary nature without the express written permission of Bray International, Inc.
Installation, Operation, and Maintenance Manual INTRODUCTION The Bray Series 70 is a quarter turn electric actuator with manual override for use on any quarter turn valve requiring up to 18,000 lb-in [2,034 N m] of torque. Operating speeds vary between 30 to 110 seconds.
Bray cannot accept responsibility for deterioration caused on-site. Bray Series 70 is not weatherproof until the unit is properly installed, or all conduits and applicable port connections are sealed off and prepared for storage. The units may be shipped with temporary covers to prevent foreign matter from entering through the conduit openings;...
Installation, Operation, and Maintenance Manual 10.5 Battery Backup Unit Bray offers a factory installable Battery Backup Unit (BBU) for the 24 V Series 70 electric actuator. In the event of power failure, the BBU will switch the actuator to battery power to reach its fail position.
10.8 Receptacles (Quick Connectors) Bray offers plug-in receptacles as a field or factory option for quick and easy field wiring of Series 70 actuators. Cord sets to fit these connectors can also be ordered in several lengths.
Page 48
All statements, technical information, and recommendations in this bulletin are for general use only. Consult Bray representatives or factory for the specific requirements and material selection for your intended application. The right to change or modify product design or product without prior notice is reserved.
Need help?
Do you have a question about the 70 Series and is the answer not in the manual?
Questions and answers