Table of Contents
Advertisement
DOOR PANEL PREP
1
2
3
4
12
Ensure door panel meets all
specifications.
Using the template as a guide, pre-drill
all holes into the panel.
Ensure the sliding bracket is oriented
correctly before securing it to the panel.
Loosely fit both 16mm Philips hanging
screws onto the door panel. Ensure
there is a minimum space of 3 mm
between the screw-head and the panel.
PUSH INTO CAVITY
1
2
3
4
Using a flat bladed screwdriver, turn to
raise the leveling feet. Level the rear,
outside legs first followed by the front
legs. Do not adjust the rear middle
leg yet.
Remove both screw covers before
partially pushing the product into the
cavity, pulling the hoses through as you
push to avoid crushing or twisting them.
Take care not to bend the legs.
Push the product from the outside
edges to avoid door damage.
Check the product sits level within
the cavity.
If required, the rear middle leg can be
adjusted from the front of the product
using a 5mm Allen key.
Select desired spacer width and cut
to size. Remove adhesive and fit two
spacers to each side of the product.
Push the product into the cavity from
the outside edges.
Advertisement
Table of Contents
